In case it comes to your knowledge that your iphone all of a sudden does not deliver audio via the earpiece. You are not capable of hearing phone calls, earpiece not functioning, and speaker not functioning, merely delivers audio as you turn on the speakerphone option. Or there can be an issue in which you note audio is not delivered via headphones or headset.

You can unplug and after that, re-plug headphones or some other well-matched device into the audio jack of your iphone a couple of times. This has solved some issues without visiting any iphone repair places.

In case you want to utilise speakerphone to obtain audio in the phone call, it will be needed to replace the earpiece speaker of your phone. Below is given guidelines to replace a dying or dead earpiece speaker of the device – iphone 6

Click the Gadget Reviews to know more about Iphone.

Here is a list of tools you will need

Tools

Phillips # 000 screwdriver

Suction handle

Spudger

P2 Pentalobe screwdriver

Tweezers

Step 1- Pentalobe screws

Prior to disassembling the device or the iphone, let you discharge its battery less than twenty-five per cent. Any charged battery of lithium-ion type may catch fire, or it can explode by accident if it is punctured.

It is necessary to power off the device prior to starting disassembly. Take out the two pentalobe screw of 3.6mm size adjacent to its lightning connector.

Step-2 – An IS-clack opening method

Now here are elaborated three steps to demonstrate utilising the iS-clack. It makes a better tool for carefully opening your iphone 6. In case you do not go for the iS-clack, leave out three steps for some other alternate procedure.

In case the depth gauge of the plastic is connected near the centre of your iS-clack, take it away now because the big phone such as iphone 6 does not need it. Shut the handle over your iS-clack and opening jaws of the suction cup.

Step 3

Position the bottom of the device amid the suction cups. Place the upper suction cup of the iSclack onto its display, a bit above but not overlapping the home button. Open the handles so that to shut the jaws of your iS-clack. Place the suction cups in the centre and press them strongly against the bottom and top of your device.

Step 4

Hold the phone with care and shut the iSclack’s handle to take apart the suction cups, lift its front panel up from its rear case. The iSclack is intended to securely open the device just sufficient to take apart the pieces, however not too wide to damage its display cables. Take the two suction cups away from the device. By so doing you can continue mobile iphone repair with ease.

Step 5- manual opening method

In case there is no iS-clack available, utilise one suction cup to take away the front panel. You need to press a suction cup against its screen, just higher than its home button. Make it definite the cup is safely pressed against its screen to achieve a tight seal.

While holding your device down, use your one hand and lift the suction cup, so that the rear case from the front panel assembly can be taken apart slightly. Do it slowly and use continuous and strong force. The display assembly tends to be very tight fit.